Fits Raptor 30/50, How-To setup videos on HeliFreak
How-To setup videos on HeliFreak
Features* Main rotor hubo 64 gramso Machined from 7075 T6 aluminumo Hub mounts using a pin and clamp design.+ Clamp design eliminates hub rocking on the shaft yielding crisp, 3D performance.+ Hub comes with four bearings pre-installed* Flybar control armo 18 gramso Machined from 7 series aluminumo The control arm is a single sided design allowing for easier disassembly and adjustment.* Washout seto 16 gramso Mixing arms are machined from 5 series aluminum+ Washout arms are equipped with set screws to secure the washout linkage pivot pins. (washout links and pivot pins are not included)+ Flange bearings are included and pre-installed.+ Washout arms are machined with an additional control hole yielding increased control and response.o Washout base+ Machined from 7 series aluminum.+ Washout base is taller than stock, the result is a wider bearing surface offering smoother, low friction movement.* Mixing leverso 12 gramso Machined from 7 series aluminumo Flange bearings are included and pre-installed yielding a slop free pivot point.o Mixing lever length is increased with an additional control hole allowing for more aggressive control.* Blade gripso 60 grams- grips, levers and hardwareo Machined from 7075 T6 aircraft aluminumo Grips are designed to be used with stock raptor bearings (not included)o Blade grip control arms are offset 3 degrees lower than stock. This allows for more leverage at extreme negative blade pitch angles.
All-in-one, all for your Heli needsOptical Tach + Whatt meter + servo tester + temp + Batt tester
Slimline design with thrust bearing fits all RaptorsHow-To setup videos on HeliFreak